Bryant T6-PRH Manual de Instruções descarregar pdf (Página 17)

12. Match and connect equipment wires to proper terminals of each connector

block being careful not to over tighten the screws. Correct polarity must

be observed when connecting the two wires from the Equipment Control

Module to the thermostat mounting base. If wires are connected incorrect-

ly, the Display Module will not operate. See Fig. 6, 7 and 8.

13. Snap cover over top of Equipment Control Module. See Fig. 12.

A07218

Fig. 12 -- Cover on Equipment Control Module

14. Turn on power to equipment. On power up, all display segments will

light for 5 sec. For the next 5 sec a 2--digit code appears on large display

which identifies Thermidistat Control configuration. Refer to Option 33.

a. AC — 1--stage air conditioner

b. HP — 1--stage heat pump

c. A2 — 2--stage air conditioner

d. H2 — 2--stage heat pump

e. hh — Hybrid Heat system with 1-- stage heat pump

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 75 76

Sem comentários

Bryant T6-PRH Manual de Instruções Página 17